Welder

Welder

Location: Palmerton, PA, United States, 18071

Company: Chart Industries

Ensuring Chart's Success?

Hiring at Fronti Fabrications in Palmerton, PA - a Chart Industries company!

Wages for welders starting at up to $32.00 per hour.

Operating Hours ? Monday through Thursday ? 6:00-4:30. Must be available to work OT beyond normal operating hours as needed.

What Your Day-to-Day Activities Will Be?

Must train and pass a minimum of 6G level GTAW

GTAW B-31.3 on Aluminum pipe a plus, but not required

Must weld to x-ray quality at all times and when required, pass x-ray and dye penetrant check of welds

FCAW to ASME standards

May weld with other processes and varied weldments and metals as warranted

Works from drawings and specifications

Must identify material and markings to ensure proper piece parts and identification codes are present

Identify and use proper Work Instructions and other related specifications

Must perform fit-checks prior to final assembly with potential to rework fitments to meet drawing specifications

Responsible for quality of weld joint and proper identification of the weld

Setup and operation for ideal welding conditions

Perform minor maintenance on all welding machines such as change torch, foot pedal, fuses, load and adjust MIG wire feeder, and check coolant reservoirs daily.

Set up and operate portable plasma cutter

Preheat preparation prior to welding per instructions

Must keep work area clean and maintain shop housekeeping

May need to perform a job from start to finish including cut/prep /Fitting/ Welding

Unloading and loading of fabricated equipment or inhouse materials

Your Education Should Be?

Must have a certificate/degree in welding from a certified technical college or 12 months of professional welding experience.

Your Professional Experience Should Be?

The candidate must have sufficient knowledge and ability to:

Use and interpret sub-assembly drawings.

Must have good dexterity and hand-eye coordination.

Understand and work with welding codes, techniques, and special instructions.

Use measuring devices and have basic knowledge of math.

Work with both MIG and TIG weld processes on SS/ Aluminum and other metals when necessary.

Work closely with support groups such as Engineering and Supervisors.

Responsible for quality workmanship and requirements to reduce or eliminate hold points.

The candidate must have sufficient ability to operate:

Welding Machines (MIG & TIG)

Portable Plasma Cutter

Positioner

Oxygen Acetylene Torch

Small Hand Tools

Cleaning Tanks

Various Hand Tools

Wire Brush, Chisel, & Punches

Hand and Electric Trucks

Overhead Cranes

Various Jigs and Fixtures

Bench Grinder

Simple and Complicated Measuring Devices

Your Physical Work Environment Will Require?

Works in an average factory environment. Exposed to the following conditions: heat, sharp edges, sometimes above-average noise, burns, fumes, smoke, dust. Protective equipment and clothing provided. Works in awkward positions: bending, reaching, pulling, pushing, standing, and sitting. Lifting 0 to 50 lbs. When lifting over 50 lbs, two people are required.

Chart is an equal opportunity employer